Please use rubber gloves while working with this product! Make all preparations on surface to be bound prior to opening sealed packet. Once surface area is prepped, open nitrogen sealed pouch and unwrap tape. Hang tape so that entire surface area is exposed to ambient humidity. Water could also be sprayed to speed activation process. If water is not directly applied, wait about 25 minutes at standard humidity for resin to activate. Resin is ready when the epoxy is the same consistence as a wet noodle. Overwrap part at 45 degree angles under pressure, assuring that part is completely covered. For added strength, pull or wrap heat shrink tubing over tape and use heat gun to shrink tape tightly around tape. Wait at least 20-30 minutes before sanding and cutting.

This tape will allow you to add support and rigidity to shafts without a significant weight increase.